Home / Getting started / Extend your Cyric Environment
Embedded Files
Extend your Cyric Environment
Extend your Cyric Environment
Although it is not a requirement to be able to run Cyric, extending your environment allows you to perform Cyric tasks simultaneously which means increasing your productivity.
Adding a switch of 24 ports means that you can run at least 24 devices next to each other!
Generation 1
Plugable Hub USB 3.0 (USB and USB-C)
Plugable Hub USB 3.0 (USB and USB-C)
Cisco Switch SG-250 24-ports
Cisco Switch SG-250 24-ports
Generation 2
Sitecom CN-379 USB-C
Sitecom CN-379 USB-C
TP Link TL-SG3428 24-ports
TP Link TL-SG3428 24-ports
The hubs are meant to unify the input required by Cyric. As you might know, every device requires a network cable and a bootable USB to be able to start Cyric. Using a hub can simplify things by using a single USB cable. This also prevents connector clips attached on the network cable from breaking which happens on about 90% of all cables.
The USB cable of the hubs can also be swapped with a USB-C variant, which comes in handy for devices that only allow USB-C input.
Click here to continue reading where you left of in the Get started guide.
Page updated
Report abuse